If msdos is not listed as the default, you will need to enter msdos at the appropriate prompt, as shown in the example below: Warning: The existing label on sd x will be destroyed and allĭata on this disk will be lost. You will be prompted to create a disk label type. Use parted to delete all partitions and create a new bootable FAT32 partition:Įnter the following commands in the order listed and follow the prompts to dev/sda or /dev/sdb), and 1 indicates the first partition. Where X is the drive letter for the USB flash drive (for example, If Linux has automounted the device, unmount it first. Note - These steps require superuser ( su - root) access. Nov 12 13:19:29 server kernel: sd 4:0:0:0: Attached scsi generic sg2 type 0 Nov 12 13:19:29 server kernel: sd 4:0:0:0: Attached SCSI removable disk Nov 12 13:19:29 server kernel: sd 4:0:0:0: Assuming drive cache: write through Nov 12 13:19:29 server kernel: sd 4:0:0:0: Write Protect is off Output is shown below: Nov 12 13:19:29 server kernel: scsi 4:0:0:0: Lexar, Inc. You should see the device name (such as, sda or sdb). Use the tail command to identify the USB flash drive’s device name. Insert the USB flash drive into a working USB 2.0 port. Where version represents the Syslinux version number. This procedure requires the use of parted utility version 1.8.6 or later.Įxtract (unzip) the contents of the syslinux- version. How to Prepare the USB Flash Drive on a Linux (Red Hat/SUSE) System Before You Begin

Install linux on usb drive